How to remove Crankshaft Timing Pulleys
3 posts
• Page 1 of 1
How to remove Crankshaft Timing Pulleys
by Spicoli » Sun May 31, 2009 7:07 pm
Like it says on a 4g64 how the fuck do you pull the timing pulleys off of the crankshaft? I'm doing a balance shaft eliminator and I need to take off the "front case" to pull off/out the oilpump and its balance shafts.
--keRby
Ad Inexplorata
LethalEthan wrote: I wish I had 10 exhaust pipes, I bet that shit flows like LL Cool J
Ad Inexplorata
-
Spicoli - VIP
- Posts: 383
- Joined: Sun Apr 19, 2009 8:21 am
- Location: KS
Re: How to remove Crankshaft Timing Pulleys
by Spicoli » Sun May 31, 2009 7:25 pm
My original balance shaft belt broke, and I dont want it to do it again and mess some major stuff up
--keRby
Ad Inexplorata
LethalEthan wrote: I wish I had 10 exhaust pipes, I bet that shit flows like LL Cool J
Ad Inexplorata
-
Spicoli - VIP
- Posts: 383
- Joined: Sun Apr 19, 2009 8:21 am
- Location: KS
Re: How to remove Crankshaft Timing Pulleys
by Spicoli » Sun May 31, 2009 7:38 pm
And how does one bust loose the bolt? Impact did no good. Pipe wrenche and braker bar perhaps?
--keRby
Ad Inexplorata
LethalEthan wrote: I wish I had 10 exhaust pipes, I bet that shit flows like LL Cool J
Ad Inexplorata
-
Spicoli - VIP
- Posts: 383
- Joined: Sun Apr 19, 2009 8:21 am
- Location: KS
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests