mightyram50.net

will these blocks fit up to my manual tranny ? jw wonder found a good deal on one
-thanks

you need a gen 1 gear box or a mitsi sigma (not sure wot you call them over there?) note the gear stick is about 2" further back than the gen 1 box, and the drive shaft out put shaft is smaller than the gen 1 box

so my tranny wouldn't work then correct? if so then can a 2nd gen motor bolt up?

yer people turbo 2.6 motors all the time, they go nuts

ya but i got the 2.0 anybody turbo those?

if its a 2.0 it should be the same as a 4g63 then your tranny will work

ok perfect