mightyram50.net • View topic

by **Johnboy72** » Fri Aug 28, 2009 8:04 am

What did you do to your truck today?

by Johnboy72 » Fri Aug 28, 2009 8:04 am

Have a thread like this on my four wheeler site. So out of curiousity, what did you do to your truck today.

I rolled the truck out, put the bed on and turned her around in the driveway. Have to clean my garage, organize my 2.6 parts for storage and prepare for 4g63 install.

by **MMaxx94** » Fri Aug 28, 2009 8:58 am

Re: What did you do to your truck today?

by MMaxx94 » Fri Aug 28, 2009 8:58 am

nothing =( need to get it hauled over to my new residence...

94 Max
<Under ConsTrucKtion>

00 Dakota 4X4
V8 Magnum Mud toy =)

04 Mustang [DD]
true dual exhaust, rims, custom audio & interior, lowering springs

http://www.myspace.com/XoStangBabyXo [add mee]

by **qballd50** » Fri Aug 28, 2009 10:52 am

Re: What did you do to your truck today?

by qballd50 » Fri Aug 28, 2009 10:52 am

Hopefully This Week end I will Reset The Timing On It!
Is Been out for 2 weeks know!

by **4doorciv** » Fri Aug 28, 2009 11:13 am

Re: What did you do to your truck today?

by 4doorciv » Fri Aug 28, 2009 11:13 am

Yesterday I took it out for a drive to get food. Today it's sitting till I get off work. Put in the buckets hopefully and clear out some junk.

-Ryan-
1989 mighty max 4g63 turbo. -down-
1995 Eagle talon tsi awd. -daily-
1992 Honda civic b18c1. -sold-

by **TurboMax** » Fri Aug 28, 2009 1:51 pm

Re: What did you do to your truck today?

by TurboMax » Fri Aug 28, 2009 1:51 pm

I had to redo my exhaust again, since part of it broke off the other day. Technically, it was just the exhaust tip, but its about a 4 foot long tip.

My 2.6 turbo swap
http://home.fuse.net/remo/2.6_turbo_swap.pdf

by **LethalEthan** » Fri Aug 28, 2009 6:35 pm

Re: What did you do to your truck today?

by LethalEthan » Fri Aug 28, 2009 6:35 pm

oil change + engine restore. Finaly putting a new lip on it tonight after i repaint my bumper.

by **Johnboy72** » Fri Aug 28, 2009 8:38 pm

Re: What did you do to your truck today?

by Johnboy72 » Fri Aug 28, 2009 8:38 pm

Ok about halfway thru cleaning, I made another mess. Tried drilling 50cal bullets out for switch extenders with no luck. Then tried filling 7.62 shells with solder to make switch extenders. No luck. So I said hell with it and remade a panel to house my switches and air guages. Then noticed my bare metal airtank collecting surface rust. So painted that up too.