FS: 1988 2.6L Engine Parts.

[4g63mightymax]

Hi John,
Carb is still there attached to the intake manifold. The oil pan is long gone.

[Johnboy72]

Well I think Kerby just sent me an intake...was it a 5spd or auto intake? Cause apparently there's a difference. How much? for carb and intake then?

[defwin]

Alternator?

[pennyman1]

timing chain cover?

[4g63mightymax]

Alternator is gone, timing cover is still available, but I think it may have some wear marks on the inside where the timing chain slapped. I will check it out and report back.

[88PowerRam50]

Looking for the shielded oxygen sensor connector and wire that goes to the ECU, plus the two "thermo valves" or thermal vacuum valves (4 and 2 nipples) that regulate the vacuum to various carburetor functions via engine temp. They screw into the water outlet near the thermostat. Mitsubishi wants way too much ($70 and $45). The nipples are bad about cracking or breaking. Might be interested in the carb if yours is manual transmission type and NOT for California and/or High Altitude. My original carb # is MD997442. Thanks for your time and desire to not waste good parts that others can use. Randall