it pains me to place this vehicle up for sale as i have an uncountable amount of money and hours in the vehicle. but here we go. this project started ad an 84 ram50 diesel that had more wiring and rust issues than you can save. so i pulled the motor and rebuilt it. it has has the balance shafts removed and the rotating mass has been balanced. the block was hot tanked and professionally cleaned. with fresh polishing on the crank and and itm pistons. new cyl sleeves and trued deck not too much. i ended up purchasing the raider and pulled the 2.6 auto. after modifying the starter it fit the flex plate properly. so it is mated to a fully functional auto with the proper overdrive thermo switch as well. everything works as it should. accept the tac which i never really dove into. but it can work properly with dakota digital kit. it also has fully functioning A/C with a very hard to find Mitsubishi bracket and compressor with custom fit hoses to properly match the raider system. this is no hack job i have done. it has operational head light squirters and rear defrost w/ rear wiper. while the motor was out i went and descaled the frame and engine bay. the frame was por15ed thru out the entire frame and what was left underside of it. it has the proper fuel filter/heater assy with a new Honeywell temp controller. a fresher rebuild on the turbo which was upgraded to a water cooled housing that is hooked up. im sure there is a ton of stuff im missing but i will add as i think of it. it also has a less than a year old optima red top battery. it also has aftermarket 16" rims with good 235/75/16 tires. newer brakes and odds and ends. there is about 40000 on the motor and 96000 on the truck. im really trying to get $2000 for it as a very good price but im open for discussion. the reason for the sale is i got the wife a new ride for Christmas, an 07 H3.
oh yea, rebuilt injectors about 15thousand miles ago. and a holly fuel pump for lift since the injection pump does both to help with mileage and longevity. and i did a starquest inner cooler install to without destroying the front end and looks.