[phpBB Debug] PHP Notice: in file /viewtopic.php on line 1052: date() [function.date]: It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'America/New_York' for 'EDT/-4.0/DST' instead [phpBB Debug] PHP Notice: in file /viewtopic.php on line 1052: getdate() [function.getdate]: It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'America/New_York' for 'EDT/-4.0/DST' instead [phpBB Debug] PHP Notice: in file /includes/functions.php on line 4505: Cannot modify header information - headers already sent by (output started at /includes/functions.php:3706) [phpBB Debug] PHP Notice: in file /includes/functions.php on line 4507: Cannot modify header information - headers already sent by (output started at /includes/functions.php:3706) [phpBB Debug] PHP Notice: in file /includes/functions.php on line 4508: Cannot modify header information - headers already sent by (output started at /includes/functions.php:3706) [phpBB Debug] PHP Notice: in file /includes/functions.php on line 4509: Cannot modify header information - headers already sent by (output started at /includes/functions.php:3706) mightyram50.net • View topic - Turbo
A site for Mitsubishi Mighty Max and Dodge Ram 50 Enthusiasts.
there is not 2.0 bolt on turbo except the conquest/starion 2.0 SOHC motors but that was only available in OZ or new zeland. Now one possible swap may be from a Mitsubishi cordia 1.8.. Its a smaller displacement and its in a FWD configuration but it should be bolt on. depending on where you are i know of one cordia turbo in PA that has the entire engine.
I know a guy who made his own manifold to boost his 2.4. It worked well for a while but eventually it would not hold boost pressure. He had finally narrowed it down to the shaft seal for the throttle plate. It was pushing 8-10 pounds I think. He tried changing out the throttle body nuerous times but no fix.