mightyram50.net

trying to decide on a bumper to use, its between a 4runner and the 93 up bumper cover, for the bumper cover, what parts are needed under the cover to make this work, i found a place that has the cover support and right and left brackets, sre there other parts needed under there?, iuve never seen one in real life and there isnt any in the yards out here to look at.

you should be able to get away with just those two brackets and reinforcement support

I just put the 93 and newer bumper on my 91 and it was really easy. The bumper cover is held on by plastic tabs on the top backside of the bumper support. It is not necessary to touch these (plus they look like they might snap off). There are 3 or 4 bolts (10mm, I think) underneath the center section that need to be removed. That allows you to pivot up the bumper cover to access 4 (14mm) bolts that hold on the two brackets on either side of the license plate. These brackets replace the pair on your vehicle now. Each side bracket has 2 (12mm) bolts. It was very straight forward and I'm trying to find another one for my '90.

will a 93 bumper cover for mm fit a 89 ram 50

yes it will fit fine, you'd be suprised to know how much you can swap around on these trucks

Yep. A lot of stuff van be swapped around. Not just bumpers, and not just with other Mitsubishi trucks. Some Mazda and Nissan stuff fit also.