A/C thermostat?????

[wrngwae]

Ok all i have recently got the correct A/C bracket and pump for my 4d55. and i tell ya its no fun to hunt down some of these parts. but it is a fresh rebuilt york ac compressor and btw it sounds cool. but back to my question. in the wiring diagram i have for A/C it shows a thermostatically controlled system. when i turn on the A/C it does what it is supposed to but it gets cold and i mean damn cold i put a them probe in the vent and the air comes out at 35deg. hell yea sound good dont it but,,,,,i dont think it should be that cold. am i putting excessive load on my compressor? is that thermostat in the wiring supposed to be in the vent and regulating the clutch assy to maintain a certain temp? i haven't "froze" up yet but i think it is a possibility. and input would be great. on the up side if i run a hose from the duct to my cold Coors light my mountains should stay blue lol



edit,,,,, i did get my new fan resistor put in too and i have all 4 fan speeds now too so i really worry if i run the fan on low for freezing up and doing compressor damage.

[TurboMax]

that's cold!

Make sure you didn't put too much refrigerant also.

Have you tried adjusting your AC/heater controls to see if the temps. change?

[wrngwae]

the refrigerant is right i have converted the compressor to the 134a and its cooooold, im a refrigeration tech,granted it is for industrial refrigeration but ist all about the same,,,,sorta,,,,,long story. and yes the temperature does change with dash control from the blue/red control but the compressor still stays loaded??????? what is that thermo control for or what does it due and where in the heck is it????????? now i got a innercooler, oil cooler and a trans cooler all crammed in that grill but nothing is blocked so im not getting a high discharge pressure which also creates a lock up/freeze up?????? so that is why i think it is in the wiring controlled thermothingy lol.

[4doorciv]

Should have a probe on the evaporator.

[wrngwae]

oh yea,,,, it looks like it is dash destruction time than,,,,no fun but it has to be done. lol

[LethalEthan]

It's on the evap housing on the raider.

[pennyman1]

If it has one the wiring comes out of the top of the evap box. Is your evap box open or closed in front under the glovebox; if open, you don't have a thermostat control on it, closed you do. My 80 D-50 has an adjustable stat, the 85 i had didn't. Hopes this helps

[wrngwae]

no sir it is open, i haven't had time to look real good for it but it has benn better since i started this thread,,,,,,,,,,of course it will,,,,,,,,,,after i started trying to fix it. that is how it always works