abeemanator
07-12-2011, 11:24 PM
I have a Weber 32/36 dfav on my 1987 Mighty Max, And just recently I started having an issue when starting the truck. When I start it cold, it starts, and idles fine, and smokes a tiny bit when first started, but after it warms up and I shut the truck off, and start it a few minutes later I must hold the pedal to the floor, and crank it for 2-3 seconds, and it starts and smokes like crazy, doesn't want to idle. ect. After about a few seconds it is fine. But one time I did the same thing and had the front end pointed down hill, and I had about 7 people in my truck, two in the front, and 5 under the camper shell,(so about 1050 lbs (Give or take 100) more than I usually have in the back, and of course it was hard to accelerate) and it was a pretty hard to start after we arrived at our destination and were on our way back, and after it did, it violently "Chugged" as I was driving, so I held the clutch and floored it and it would only go about 3000rpm, but slowly it climbed back up, and after that, it ran fine.
So, what do you think is causing this, I talked to an old mechanic and he says that gas could be coming out of the float when I turn it off, and it causes it to flood. Also I am missing the AFM screw (I think) to the secondary, it has never caused any problems before, but do you know where I could find another one.
So, what do you think is causing this, I talked to an old mechanic and he says that gas could be coming out of the float when I turn it off, and it causes it to flood. Also I am missing the AFM screw (I think) to the secondary, it has never caused any problems before, but do you know where I could find another one.