Mighty Max Rear Question

[brownievtec]

I have a 2.0 Mighty Max 2wd Im doing a 4g63t swap very soon and in need of finding a driveshaft spacer about 1.5in this is so i can move the engine forward for clearance... Didnt know if anyone knew of any trucks or suv that use the same driveshaft flange

Thanks
Mike

[camoit]

I have never herd of one. It would be best to take the drive line to a shop and have it rebuilt to the length you need.

[brownievtec]

I think im going to just Cut the firewall or dent it but thanks tho

[camoit]

i would look at droppedmitsu's truck he did the swap. Look in his profile for his photo gallery or his build thread. it might give you an idea on whats involved.

[DroppedMitsu]

Without any bending/cutting of firewall you're going to want to go atleast 1 7/8" if you want to be able to work/get at things on the back of the motor. I just got my driveshaft lengthened, but it wasnt too expensive because i have a two piece driveshaft and they just made a new piece for the shorter piece.

[brownievtec]

I'll just have to see what my Clarence is like... I was going to bang the firewall a lil or cut part out and box it I just have to see how much room their will be when I mock up the 1g eclipse dash

[pennyman1]

You may be able to find a front driveshaft section the right length from the 1st gen 2wd trucks - each tranny had a different length front driveshaft. I think the lengths are in the manuals posted online. If your truck has a 1 piece driveshaft it won't help you.

[DroppedMitsu]

good luck with the eclipse dash. I was thinking about doing it too but it was way too low and came too far back into the cab for the shifter when I put it in my parts truck and took up too much space, but it could be made to fit for sure.