Results 1 to 2 of 2

Thread: 2g 4g63t swap clutch issues

  1. #1

    Array
    Status
    Offline
    Join Date
    07-01-2022
    Posts
    9
    Location

    Mount Hope West Virginia
    Vehicle

    1987 Dodge Ram 50
    Engine

    G63B

    2g 4g63t swap clutch issues

    I’ve gone and put in a 2g 4g63t into my mighty max/d 50. It’s mated the original KM132 trans mission using the Eclipse flywheel and pressure plate and the trucks disc.
    With the clutch disengaged (pedal up) and the trans in gear there is no vehicular movement. With the rear off the ground and the trans in gear I can spin the driveshaft, see the gears in the transmission spinning and hear the disc scuffing (slipping). There isn’t enough contact to drive the remaining components. What am I missing here?
    Thanks in advance George the Painter

  2. #2

    Array
    Status
    Offline
    Join Date
    06-15-2014
    Posts
    6,059
    Location

    Adelaide, South Australia
    Vehicle

    1985 Mitsubishi L200
    Engine

    G63B
    There may be an issue with the thrust bearing and/or bearing carrier. There are 2 types and one travels further towards the clutch assembly. And I know this one is kind of obvious but also check the clutch cable adjustment...

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •