Results 1 to 2 of 2

Thread: 2nd gen. Making a Lil progress

  1. #1

    Array
    Status
    Offline
    Join Date
    02-05-2015
    Posts
    15
    Location

    Ogden, Utah
    Vehicle

    1989 Dodge Ram 50
    Engine

    G63B

    2nd gen. Making a Lil progress

    So After sitting on the side of my house the past 7 years, totally forgotten on the back burner, I finally pulled the 89 out and started getting it road worthy again. Got it running, Still got to get rid of knock off carb and get a real one..... but in the mean time it got full 2.5"F- 4"R beltech lowering kit. Quotation I have, is what is causing the driver side front to sag? I've put 3 sets of leaf springs under it, 3 says of coil springs under it and still there is a visible dip in the driver front side. The only thing is I haven't got it aligned yet, but unless the torsion bar is way outta wack I don't know what is causing it. Any suggestions or ideas???

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,857
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    check the coil springs - one should be taller than the other - that is the driver side coil. the rear shouldn't matter.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •