Results 1 to 3 of 3

Thread: Rearend Fitment

  1. #1

    Array
    Status
    Offline
    Join Date
    04-29-2017
    Posts
    11
    Location

    York, SC
    Vehicle

    1994 Mitsubishi Mighty Max
    Engine

    4G64

    Rearend Fitment

    I was wondering if you could fit a 1st Gen rearend differential assembly in a 2nd Gen? Because I found a 1985 long bed Ram 50 with a 3.54 gear ratio and my 1994 Mighty Max has a 3.90 gear ratio.

  2. #2

    Array
    Status
    Offline
    Join Date
    01-24-2017
    Posts
    1,219
    Location

    New Zealand
    Vehicle

    1981 Mitsubishi L200
    Engine

    Other
    Yes, it's functionally the same

    There are some differences. I did the reverse, a 2nd gen lsd diff into my 2st gen

    They have different brake setups, later ones have duel action pads vs the leading edge ones in thr early diffs. On paper the later set up is better.
    And the brake hose mounts are different, I found it easier to use the 2.d gen hose on my 1st gen, I think it might be fine the other way round.

    Otherwise it bolts in fine

  3. #3

    Array
    Status
    Offline
    Join Date
    04-29-2017
    Posts
    11
    Location

    York, SC
    Vehicle

    1994 Mitsubishi Mighty Max
    Engine

    4G64
    Ok thank you for the info. I'm glad to hear that. I will be pulling the rearend differential axle assembly this weekend. I will swap it out asap and give my feedback on it. ������

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •